This micros2u Suction Cup Mount comes with an Anti-Skid suction Base + Easy Press Button when mounting to a surface.
The suction cup can Universally fit other Makes of Digital or Video cameras, that can accept 1/4" Screw and take a total of 2.5kg weight.
Suction Cup Mount can be widely used in Cars, Boats, Windscreens, Fish Tanks, and smooth clean Surfaces, etc.
Main Arm's angle can be adjusted up while the Screw Mount can be adjusted all the way up to a full 360 Degrees.
Compatibility: For HERO HERO2 HERO3 HERO3+ HERO4 HERO5, HERO 6 HERO 7 SESSION or other cameras accepting 1/4" screw
Material: PC + ABS + Stainless Steel
Max Load: 2.5kg/ 5.51Lb
Base diameter: About 9cm/ 3.5in
Height: 7.4 -12.3cm/ 2.9-4.8in
Weight: 187g/ 6.56oz
1 x Suction Cup Mount
1 xTripod Mount
1x Stainless Steel Coated Safety Tether
How to Use:
1. Remove the plastic film underneath the suction pad.
2. Mounting the Suction Cup, mount to a dry clean smooth surface. (Use a cloth or rag to make sure the surface is dry and clean)
3. Mount the suction cup to the chosen surface, whilst holding the "Press Button", Flip the Hinge over to the opposite side to create a strong vacuumed suction.
4. Now you can mount your Camera to the suction cup screw adapter, and adjust the angle as required.
5. To un-mount the suction cup, just flip the hinge back to the opposite side again, then use one finger to slide the Small flap under suction pad up whilst lifting the entire suction cup mount from the surface.
6. That's it all done: just make sure to always mount to an clean, dry, smooth surface.
- Additional Information